Sandcraft Motorsports Gen 3 Carrier Bearing Rebuild Kit

Sandcraft Motorsports Gen 3 Carrier Bearing Rebuild Kit

Looking To Freshen Up Your Sandcraft Gen 3 Carrier Bearing, This Kit Is A Full Rebuild. Replaces Bearings, Rings, Seals And More. Rebuild Your Carrier Bearing

This is Only The Rebuild Kit, Not Full Carrier Bearing

Fits All Polaris & Can-Am Gen 3 Sandcraft Carrier Bearings. Will Not Fit RZR 900 2012-2013 Gen 2 Carrier Bearings. 

Fully Sealed Bearing & Fully Greasable

We have created and patented this design to be a GREASABLE bearing while having 3 layers of protection to keep dirt, sand, mud, and water out.

Self-Aligning Bearing

Patented Design, Sandcrafts Auto Set Angle self-aligning bearing reduces side load on your carrier bearing from the prop-shaft – a must have if you want to keep vibrations to a minimum and the life of your bearing long.

Our all new auto set angle & 2 piece design will lower installation time dramatically, It allows you to press the bearing onto the shaft and install with minimal effort.

Side loading the bearing leads to pre-mature wear and failure. The auto set angle eliminates this from happening to your car.

We are the ONLY COMPANY in the world with this design so don’t waste your time with the copycats.

Features:

• New SKF Bearing.
• Dust Shield.
• Grease Ring.
• Retainer Snap Ring and Brass Ring.
• Works with ALL SandCraft Carrier Bearing Models

Learn More About Sandcraft Motorsports: